Meeting Minutes : Phorum 5
The monthly meeting minutes.
The working principle of the smallest Raymond mill
Posted by: kuangshanposui (---.148.16.81.vultr.com)
Date: July 09, 2018 08:38PM
The grinding roller is tightly pressed on the raymond mill ring under the action of centrifugal force, and the material is sent by the blade to the middle of the grinding roller and the grinding ring. The material is broken into powder under the action of the rolling pressure, and then the fan is used under the action of the fan. The powdered material is blown up through the analysis machine, and the material that meets the fineness requirement passes through the analysis machine, can not reach the required heavy return grinding chamber and continues to be ground, and is separated and collected by the material of the analysis machine into the cyclone separator.
Changes in the grinding chamber during grinding work:
During grinding, the material in the grinding chamber has a certain water content. The heat generated during grinding causes the gas in the grinding chamber to evaporate, which changes the gas flow, and the connection of the pipes of the whole machine is not tight, so that the outside air is sucked in, so that the circulating airflow increases. This causes the mill to produce less powder or even blast. In this regard, Raymond Mill has set up explosion-proof measures on the upper part of the body to avoid accidental damage caused by the explosion of the Raymond mill. The airflow is balanced by adjusting the residual air duct between the fan and the main engine, and the excess gas is introduced into the small cyclone collector, and the fine powder brought in by the residual gas is collected, and finally the upper exhaust pipe of the small cyclone collector is collected. It is discharged into the atmosphere or introduced into the dust collector to purify the exhaust air. However, the technical requirements of the operator are relatively high and need to be discovered and adjusted in time.
The space inside the main grinding chamber of the mill is limited. If the grinding roller is installed more, the grinding space of the grinding chamber will be reduced, the material volume ratio will be reduced, and the output will not be too high; however, there is no benefit from one more grinding roller. Yet? It can't be said that the same model, grinding low-hardness materials, the required fineness is the same, it is definitely that the grinding roller has a higher output, because the grinding space is large, the volume ratio is high; if it is grinding some hard materials, One more grinding roller has one more grinding process, which is higher than that of one less grinding roller.